I prefer the heavy nylon straps with tighteners rated at 3300 lbs for hauling cars, but some prefer chains. The floor of the U-haul trailers is galvanized steel, so the load can be slid into place relatively easy - but this means it must be tied down well so as to not allow the load to move under road stress such as sudden stops. In any event, you do not want the load so far back in the trailer that it is trying to lift the tongue while driving down the road. ![]() When finished loading, the load should be almost centered on the trailer axles, but slightly forward to put a load of about 200 lbs on the ball- my experience is trailers tend to pull with more stability when so loaded. Laat een reactie achter als u een handleiding via de mail wilt hebben. Zoals Barcrest, Errel Bellfruit, JPM en nog veel meer. ![]() Wij zijn in het bezit van vele technische handleidingen, dus puur de techniek en algemene dingen. If putting a large load on the back end of the trailer, back it under, then block the back of the trailer so the hitch ball does not have to support a lot of force upward (most likely you will need a jack to remove these blocks when finished loading). Gokkasten Archief » Community » MPU4 handleiding. Hi can anyone help me out with a pdf of manual and wiring diagram hopefully to include wiring on the MUX5E PCB too regards. Also, I lift the load high enough to back the trailer under it rather than vice-versa.
0 Comments
Leave a Reply. |